2021 Seawind 1260 Owners Version

Características adicionales, equipo e información:

Nombre del barco
New Build

Características
Constructor: Seawind Catamarans
Garantía: 5 años
Quilla: Corrida
Forma del casco: Catamarán

Dimensiones
Eslora total: 41 Pies 0 Pulgadas
Manga: 22 Pies 4 Pulgadas
Calado máximo: 3 Pies 8 Pulgadas
Desplazamiento: 18165 Libras

Motorización
Potencia Total: 60 HP

Motor 1:
Marca del motor: Yanmar
Año de construcción: 2018
Tipo de motor: Intraborda
Tipo de motor/combustible: Diesel
Ubicación: Estribor
Hélice: Hélice abatible
Tipo de transmisión: Sail drive
Potencia del motor: 30 HP
Motor 2:
Marca del motor: Yanmar
Año de construcción: 2018
Tipo de motor: Intraborda
Tipo de motor/combustible: Diesel
Ubicación: Babor
Hélice: Hélice abatible
Tipo de transmisión: Sail drive
Potencia del motor: 30 HP


Depósitos
Número de depósitos de agua dulce: (185 Galones)
Número de depósitos de combustible: (126 Galones)
Número de depósitos de aguas negras: (63 Galones)

Alojamiento
Número de literas dobles: 3
Número de camarotes: 3
Número de aseos: 2

Equipo Eléctrico
Circuito eléctrico: 110V

Equipamiento Exterior
Molinete eléctrico

Exterior and Laminate

• Finish:  Full female moulded hulls & decks, exterior gelcoat finish with moulded-in non-slip surface on deck areas.
• Hull Laminate: Vinyl Ester (Modified epoxy) resin laminate of the hulls between the gelcoat and the foam core. Polyester resin elsewhere. Laminate specifications are to Australian survey compliant and international standards including European CE certification.

Mast/Boom/Sails

• Clear anodised aluminium mast and boom. Single Spreader,  7/8 rig.
• Standing Rigging   - Forestay 3/8 (10mm) 1 x 19 Dieform wire.                                                        
       - Sidestays 3/8 (10mm) 1 x 19 Dieform wire
       - Diamonds 5/16 (8mm) 1 x 19 Dieform wire.
   
• All fitted with turnbuckles and T-ball end fittings.
• Halyards      - Main halyard:  12 mm Spectra rope : Heavy duty shackle.
       - Genoa halyard:  8 mm Spectra rope. Heavy duty shackle.
       - Topping lift:  10 mm rope, Heavy duty shackle.
       - Spinnaker Halyard:  12mm rope with snap-shackle spliced to end.
• Boom outhaul.
• 2 x mainsail single line reefing fitted.
• All halyards, reefing lines to be lead back to cockpit through turning blocks, rope clutches.
• Fully battened mainsail – Fibreglass sail battens. Roller bearing batten cars.
• Cruising mainsail cover with integrated lazy jack system.
• Self-tacking headsail. Curved headsail traveller track with end stops. Control sheet to cockpit.
• Headsail furler

Deck Equipment

• Aluminum Hatches & portholes (9 in total)
         - 4 x Forward Hatches 470mm x 470mm
         - 2 x Mid cabin hatches 470mm x 470mm  
         - 1 x Port Bathroom window hatch 507mm x 377mm
         - 1 x Galley window hatch 507mm x 377mm
         - 2 x Aft Cabin window hatch (1 x Port, 1 x Starboard) 507mm x 377mm  
• Fiberglass Deck Hatches:
          - Forward anchor & storage hatches x 5
• Cockpit storage hatches
• Cockpit Icebox & hatch
• 6 x Docking cleats. Each side: bow, stern & amidships.
• 1 x Heavy duty mooring cleat on forward walkway.
• Ventilation: 2 x forward cabin hatch vents.
• Mast base turning blocks. All halyards & sail controls to cockpit.
• 12 x Rope clutches.
• Manual Sheet winches: 1 x 46ST – 2 speed self tailing & 2 x 40ST – 2 speed self tailing.
• Stanchions/Rails:  High quality stanchions, bow rails and stern rails with 3 life-lines.  700mm high to meet Australian survey requirements..
• 2 x transom access gates with pelican hook releases.
• 2 x side access gates with pelican hook releases.
• Aft swim ladder: folding stainless aft swim ladder.

Forward beam, Catwalk and Trampolines

• Forward beam section 125 x 3mm.
• Adjustable pelican striker and cable.
• 1 x Mooring rollers above foredeck.
• 2 x Anchor roller under deck.  Permanent stowage position for 45lb CQR anchor.  (cheeks 75mm high).
• Catwalk in foam-sandwich fiberglass.
• Plastic coated open weave trampolines.

Aft beam and deck

• Moulded fibreglass Targa Bar with curved mainsheet track.
• Stainless steel framed slatted seats behind aft beam. Fibreglass top table between seats.
• Stainless steel BBQ.
• Stainless steel dinghy davits shall be fitted.

Rudder System

• Twin raised helm stations (dual) with hinging backrests Vinyl Upholstered: 2 X 32” stainless steel steering wheels.
• Both wheels independently linked to steering system. – system offers back-up redundancy.

Interior Finish

• Beech finish interior.
• Sides and cabin top lined with vinyl or molded gelcoat.
• Floors : Common area soles simulated teak with holly inlay.

Salon

• Ornate polished timber dining table:  Lowers to create coffee table or double bed.
• Upholstered settee with day lounge
• Cocktail cabinet/storage under day lounge
• Polished timber chart table
• Forward opening windows in 10mm toughened glass in marine anodised aluminium frame. Side windows in 6mm toughened glass.
• Simulated teak & holly flooring.
• Saloon / cockpit doors:  Molded gelcoat, tri-fold doors. Complete with folding mechanism for folding into Targa walkway.

Galley

• Spacious galley with co-ordinated Polystone counter surfaces, timber accents.
• Three (3 ) burner LPG stove & oven. Stainless steel pot holders. Flame failure device to shut off LPG immediately in event of flame going out.
• Double bowl stainless steel sink.
• Pressure hot & cold fresh water system.  Single lever mixing tap.
• Refrigerator : Front opening upright  fridge 130 litres.
• Spacious freezer – large 60 litre draw loading, heavily insulated. 12volt Eutectic system by ICEER.
• Under bench storage with polished timber door fronts & cutlery drawers.
• Inboard side of galley: Over-bench cupboard with sliding door fronts
• Simulated teak & holly flooring.
• LPG solenoid control in galley

Sleeping Cabins

• Polished timber solid doors on all private cabins.
• Port & Starboard fwd cabins : Each queen sized bed (2050mm x 1540mm)
• Aft Starboard cabin : Double bed (1990mm x 1230mm)
• Mattresses to be 150mm ( 6” ) quilted foam upholstered.
• Cabins lined.
• Recessed 12volt lighting.
• Storage/Cupboards.
• Carpeted floors.

Port Head

• Polished timber solid lockable door.  
• Manual toilet. Discharge via holding tank.
• Holding tanks built in. Discharge Pump out by shore station or directly overboard. Port 130L and Stb 110L.
• Pipes, skin fittings and sea-cocks are easily accessible and to meet survey requirements.
• Vanity basin with pressure hot & cold water.
• Wall mounted shower head & mixer tap.
• Electric shower bilge pump with direct overboard discharge.
• Large quantity cupboards / shelves to very high quality.
• Toilet roll holder, towel rack & mirror mounted

Starboard Head

• Polished timber solid lockable door.
• Manual toilet. Discharge via holding tank.
• Holding tank built in. Discharge Pump out by shore station or directly overboard.
• Pipes, skin fittings and seacocks to be easily accessible and to meet survey requirements.
• Vanity basin with pressure hot & cold water. Shower head and basin mixer tap with electric shower bilge pump.
• Cupboard/shelves to very high quality.
• Toilet roll holder, towel rack & mirror mounted.

Lighting/Electrical System

• High quality DC electrical switch panel with circuit breakers, LED indicator lights and voltage display.
• Marine grade tinned electrical wiring with extensive use of heat sealed connectors..
  Batteries x 3 comprising:  House System (400 amp hrs) : 2 x 200 amp hr AGM (Absorbed Glass Matt) deep cycle / heavy duty batteries. One engine cranking battery – 700 CCA AGM.
• 230amp heavy duty isolation switch.
• BEP Battery Monitor
• 12 V lighting : Numerous 12V LED interior lamps and courtesy lights throughout including recessed lights in cockpit. Dome lights in cockpit. (All lights except fluros are LED)
• 4 x 12V Outlets.
• Survey approved LED navigation lights. Port & Starboard mounted on bow rails.
• Deck floodlight mounted on spreaders.
• Mast head anchor / riding light.

Plumbing/Fresh Water Tanks

• Pressure hot & cold water system. Hot water storage system ( 40 litre / 8.8 gallons) . Hot & cold water to galley and both bathrooms.
• Galley fresh water tap is lever type ( Flickmaster or similar).
• Fresh water tank: 700 litres ( 156 gallons). Remote deck filler.
• Electric fresh water pump.
• Electric bilge pumps (2) with controls integral with master battery switch panel.
• Float Switches (2).
• Manual bilge pumps (2) in each hull.
• Through-hull fittings to Australian & CE survey standard.
• Manual toilets in each head.
• Port bathroom with separate shower stall. Starboard bathroom with dual purpose faucet & shower.
• Electric sump pump for shower drain.
• 2 x LPG bottles – 4.5kg galvanised.
• Fresh water tank gauge.

Engines

• Twin Yanmar 30hp saildrive diesel engines. Fresh water cooling, rubber isolation mounts on reinforced fiberglass bed with integral oil drip pan.
• Two bladed folding propellers.
• Fuel tanks: Total 440 litres (98 gallons) in two survey approved pressure tested aluminium tanks. Fuel gauges fitted.
• Water intakes for engines protected by external strainer. ( 1 per engine)
• Twin primary Racor ( or similar) water separator / fuel filters, secondary engine fuel filters. Engine, fuel tank & fuel line installation to Australian standards.
• Console mounted engine instruments with electric tachometers, engine monitoring & warning systems, engine hour meters.

Navigation

• Twin steering compasses.
• DSC VHF radio.

Anchoring and Mooring

• Electric anchor winch with chain & gypsy. Located under locker to give clean deck.
• Primary anchor is 45lb CQR type with 55 mtrs x 8mm short link galvanised chain.
• Primary anchor is stored in a specially designed anchor roller under the forward beam.
• Anchor winch has foot switch at the winch plus a remote up / down control at the helm station.
• 3 x PVC Inflatable Fenders
• 4 x Mooring lines (each 15 meters x 14mm)

Antifouling/Striping

• Epoxy barrier coat plus 2 coats of high quality Altex antifouling bottom paint.
• Seawind 1250 decals on each hull and stern.

Disclaimer
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.