Boat is in good condition! Brokerage commission 4% apply on price.
Sales & Purchase Specialists
Please contact Master User at +385 95 906 1060
Características adicionales, equipo e información:
Forma del casco: Monocasco
Eslora total: 9.50 m
Manga: 3.23 m
Calado máximo: 1.90 m
Potencia Total: 21 HP
Marca del motor: Yanmar
Tipo de motor: Intraborda
Tipo de motor/combustible: Diesel
Potencia del motor: 21 HP
Número de literas dobles: 6
Número de camarotes: 2
Número de aseos: 1
Número de baños: 1
Toma de puerto
Circuito eléctrico: 12V
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Manufacturer Provided Description
Derived from the famous Figaro Bénéteau, this 31 footer is an aknowledged benchmark in cruising as well as racing.
Deck plate for detachable forestay.
?Tuff Luff? grooved forestay (in place of genoa furling gear).
Wide sprayhood with two frames, in grey.
Pulpit with opening forward.
Freshwater foot pump.
2 lee cloths.
50 L or 88 L rigid WC holding tank with sea/shore pump-out.
Waterproof speakers to cockpit.
Raymarine 3 display Multifunction Repeaters to mast with ST60 remote control.
Automatic pilot: ST6001 Plus controller and computer with compass and LS40 helm drive.
Raymarine PC Interface (RS32 input/output series in PC format).
Convenient stowage space and handling positions:
Teak slatted cockpit seats.
Two teak slatted helm seats port and starboard, sloping outwards for more comfort at the helm.
Two stainless steel handrails bolted to
21 HP Yanmar Sail Drive engine.
Engine compartment insulated with alveolate foam.
Fuel tank with approx. 30 L capacity and sediment filter.
Engine hatch built into the cockpit.
Water and fuel filters and sediment reservoir.
The hull is single-skinned laminated GRP.
A structural inner moulding with uni-directional fabric is bonded and laminated to the hull. Its structural role is important as it takes and absorbs the stresses at pressure points (chain plate tie rods, keel, rudder etc.) and spreads any loads, guaranteeing reduced strain on the hull. The surface to the inner hull makes cleaning easier and provides a better finish.
The hull gel coat is grey.
The deck is balsa sandwich construction (glass fibre, balsa, polyester resin) for an optimal strength/weight ratio and for good thermal and sound insulation.
A roughened non-slip surface increases safety over all deck surfaces.
An inner deck moulding is sealed to the deck to round off the finish.
The deck is reinforced under deck fittings (winches, tracks, U-bolts, cleats).